Quote:
Originally Posted by StrikeFreedom
For installation, I simply match up vertical slot on the barrel with the rubber, then slide it in until it meets the horizontal slot.
Again the rubber is noticeably larger than the stock rubber, so I believe this is the reason for all the squishing inside the chamber. I never lubed the rubber. I did however washed it with soap water, as it is recommended by some. Is that what enlarged/swelled it? If so, can I shrink it by putting it in cold water/frig?
|
Hey, what I also tried is to use a small phillips screw driver or tweezer and manipulate the pouty lip once it is enclosed in the 2 chamber halves. I basically tried to pull up the pouty lip until the opening is circular. Give that a try and tell me what you think.