[Biowipe]

So today I changed everything inside my M24, and installed Laylax cylinder and handle. But now have a very annoying problem: I can pull the handle just fine but when it comes back it does not go all the way in (AND IT IS NOT with an empty magazine. I also made sure the hopup screws are not in the way). The only way i can make it go all the way in, is IF while the handle is all the way back, I pull it down (as if it was in the initial position) which seems to push the cylinder a bit to the right; after that i can pull the handle back up and all the way back in.

It is obvious that something gets misaligned (pushed to the left) when the bolt is pulled but I just cant find what it is. Any suggestions are greatly appreciated.

EDIT:

After playing around some more here are few observations:
The situation repeats 100% of time when the reloading is done with the rifle pointing up
The situation repeats 5% of time when the reloading is done with the rifle in horizontal position
The situation repeats 25% of time when the reloading is done with the rifle pointing down

Now I have no idea at all whats going on