Airsoft Canada - View Single Post - We can rebuild it...Make it Faster! STRONGER! War-Locks AK-47 upgrade Project!

666 · February 15th, 2013, 16:54

I put Guarder tune up kit with Guarder clear hopup sleeve/bucking, PDI spring ( I heard now PDI springs are crap) in my TM AK converted into RPK years ago, 06-07 I think. It was shooting 400-407FPS at the time. Ran the thing until 2009 with a lot of bb's put through it since it was used mostly as support weapon. Put it in storage for 3 years. I opened mechbox past December to inspect/re grease before new season, 2-3 piston teeth slowed severe wearing so I replaced piston, otherwise everything looked just fine... I did pop can test since I don't have a chrono, bb went right through center of the bottom part.
I've been out of the loop for the past 4 years, but if Guarder is as good as it was before I'd go with it if I ever decide to buy another tune up kit.

February 15th, 2013, 16:54	#7
666 Trader rating Join Date: Jul 2004 Location: Toronto, Ontario	I put Guarder tune up kit with Guarder clear hopup sleeve/bucking, PDI spring ( I heard now PDI springs are crap) in my TM AK converted into RPK years ago, 06-07 I think. It was shooting 400-407FPS at the time. Ran the thing until 2009 with a lot of bb's put through it since it was used mostly as support weapon. Put it in storage for 3 years. I opened mechbox past December to inspect/re grease before new season, 2-3 piston teeth slowed severe wearing so I replaced piston, otherwise everything looked just fine... I did pop can test since I don't have a chrono, bb went right through center of the bottom part. I've been out of the loop for the past 4 years, but if Guarder is as good as it was before I'd go with it if I ever decide to buy another tune up kit. __________________ Op Woodsman. Biggest WW2 event in Ontario.