Quote:
Originally Posted by Spike
Awesome man!
Question now though, what is the other part of the hop kit tool for? The triangle thinger?
|
The shelf? It's basically in case you need to rework the R-hop patch channel in any way. It also makes it easier to hold if you're doing some sanding. I glued some sandpaper to the inside surface to hold patches better but for the most part I haven't really needed to use it.
Quote:
Originally Posted by Chiba
Been doing that. I can still never get the outside of the r-hop to sand down flush with the barrel entirely no matter how much I sand (of course not below the outside of inner barrel). This causes the r-hop to push down sometimes.
Also I find my R-hop isn't consistently applying spin.. sometimes I have to shoot a few BBs (it would shoot like under hopped) before it is giving me a nominal trajectory.
Anyone have an idea why? Let me know if you need specs.
|
Like I said in the video, your first install isn't going to be amazing, but if you're lifting .25g+ then a LITTLE bit of protrusion/intrusion isn't going to break the deal.
What hop nub are you using?
Also, are you testing out with a completely full mag? I ask because sometimes your tappet plate spring isn't strong enough and upward pressure of BBs pushes the nozzle out of alignment. If so, test again with a half-loaded mag.