I figured as much. New issue. Now WTF did i do. I opened it up to check out the wires. (they do look okay save for a few knics on the motor wires i think it may be just the sure tightness of the space to run all those wires through)
Befor i opened it it worked fine no issues with firing on its own and the 3round burst was right on time. (still no semi as some of you may alrdy know)
So to my supprise i found this work of beauty inside when i opened her up.
The shim job is sweet you can see the sector was runnin right down the middle.
The aoe should have been fine you can see where the lil tab sticks up on the sector that is about where it is set to.
You can see the last three orange teeth and its hard to see but the metal tooth is also busted off in there tho its still just barely held in by the plastic.
So WTH causes this?
Its onlly a stock echo1 spring 380-400 fps or so its lonex hs gears (16:1 i think they are) stock motor 9.6v battery so not a crazy fast build. In fact i didnt even have to change the timing from the stock setup for the 3rnd burst.
Do i just have that bad luck or suck that bad at rebuilding or what gives.