Quote:
Originally Posted by RainyEyes
The bushings I sold you were I believe 6mm SHS bushings (can't remember the orange ones). I do not know if the bushings are the right size for that gearbox. Each gearbox has different sizes because of reasons.
Note: no I was not the one who sold him the gearbox.
If those are the APS gears that I also sold to you, they are properly sized 18:1 standard ratio gears. I have tested them in my V3 JG gearbox so I know for certain that these are not proprietary gear sizes. The only other thing that needs to be ruled out is the gearbox size that should be the same as any other TM clone.
So above all the things mentioned, see if the bushings on the down-facing side of the gearbox are sitting flush and not protruding outwards which can result in the above pictures.
|
I have tried the same set of gears on a different gearbox and they close with a lot less gap.
Quote:
Originally Posted by Crowin
I think the lancers need 7mm shims, that must be the problem. an airsoft bb is 6mm. put one in the bushing hole, if there is space around it, its bigger than 6mm.
|
I only have 6mm and 8mm. the 8mm is too big. Assuming the gearbox is really standard, this makes the most sense.