To start off if you break your gun by doing any of the following I will not be held responsible. This is just a list and set of pictures of things I have done to my vsr.
Stock Removal
1.On the underside of the stock near the mag well you will see two allen key screws. Also make sure to remove the mag before removing the stock.
2.Now you will notice the longer screw goes towards the back of the mag well. This is the section that would be closest to you when shouldering the gun. The easiest way to tell is you can see the threads for the short screw.
3.Now lift the muzzle end of the rifle upwards and then pull forwards. This wil remove the barrel trigger assembly from the stock.
4. Make sure to not let this piece fall out. Put a piece of tape over it or something.
You are now done removing the stock.
Trigger group removal
1.First you need to remove the screw at either end of the trigger system.
2.Now pull the large pin out that has two arrows on the side of the trigger system. This pin may be in there good so use some muscle.
3.Pull the cylinder and cocking handle and the entire cylinder should remove.
Your done that now.