Airsoft Canada
https://www.replicaairguns.ca/airsoft

Go Back   Airsoft Canada > Discussion > Doctor's Corner
Home Forums Register Gallery FAQ Calendar
Retailers Community News/Info International Retailers IRC Today's Posts

JG M4A1 Misfire/Dry Fire?

:

Doctor's Corner

Reply
 
Thread Tools
Old February 15th, 2010, 15:09   #1
BGrail25
 
Join Date: May 2009
JG M4A1 Misfire/Dry Fire?

I was out shooting my Jing Gong M4 outside yesterday when I noticed it was not shooting very consistently - even though the magazine (hi-cap) was wound up all the way, a few random rounds would be blank, or pathetically fall out of the barrel.
The battery was fairly charged, I was only using it for around 10-20 minutes. (Not constantly shooting, obviously).
Like I said before, the mag was fully wound, but I have had a big problem with the coil spring in the past. The part of the spring that held onto the gear snapped, I had to pull the end of it through to hold it.
I think it could be a magazine problem, but do you think the weak shots could be connected to the dry-firing? I'd appreciate any ideas.
BGrail25 is offline   Reply With Quote
Old February 15th, 2010, 15:17   #2
Conker
 
Conker's Avatar
 
Join Date: Jan 2007
Location: Canada / Ireland / USA
First of all, get rid of the goddamn hicaps. They are evil, and whenever they are near your gun, it's suceptible to explode.

That being said, if Bs were falling out of the barrel, you probably didn't have your hopup tuned up enough.

Did those that were actually shot go approximately at the same range?
Conker is offline   Reply With Quote
Old February 15th, 2010, 15:19   #3
The Mexinadian
formerly Eddie_uv777 eh?
 
The Mexinadian's Avatar
 
Join Date: Aug 2008
Location: Robstown TX
Send a message via AIM to The Mexinadian
Probably got a round stuck in the barrel. Stick a jam rod down there.
__________________


Quote:
Originally Posted by Diabolic Tyrant View Post
You are like a Canadian Texan... No way you are american.
The Mexinadian is offline   Reply With Quote
Old February 15th, 2010, 15:22   #4
Conker
 
Conker's Avatar
 
Join Date: Jan 2007
Location: Canada / Ireland / USA
I don't recommend using a cleaning rod unless you're sure there's a BB stuck. That could potentially damage the hopup rubber.

And, if it happened a few times I'm convinced it's not a stuck BB.
Conker is offline   Reply With Quote
Old February 15th, 2010, 16:02   #5
BGrail25
 
Join Date: May 2009
I see you don't like hi-caps :P

The BB's that don't go anywhere usually fly about 5-10ft, with little power - whereas regular ones will obviously go farther.
I haven't really had any BB's that literally fall out, so it's probably not the hop-up. I don't think the BB's are getting stuck either. The sound is a very distinctive dry-firing noise, not the muffled sound a jammed gun makes.

Anyways, I cleaned the barrel, even though it might not be the main problem it might still improve it. The battery is charging, so I might have to test it out some more to see what the problem is, or if it's still there. Thanks for the replies so far!
BGrail25 is offline   Reply With Quote
Old February 15th, 2010, 17:54   #6
HKGhost
 
HKGhost's Avatar
 
Join Date: Nov 2009
Location: Mississauga, ON
I have the same problem with my gun at the moment also. I'm pretty sure it's the hop-up bucking. Replace the stock JG bucking with a Guarder one and you should be good.
HKGhost is offline   Reply With Quote
Old February 27th, 2010, 02:59   #7
addison
 
Join Date: Feb 2010
Definitely you are thing right because you was just use it for 20 minute and there is no problem regarding to battery so just check out magazine and service it in proper way it will works properly as your experience of first time.
__________________
psp memory
addison is offline   Reply With Quote
Old February 27th, 2010, 13:20   #8
BGrail25
 
Join Date: May 2009
I know it's been a while since I posted this, but I haven't really gotten a chance to test it out. Well whatever it was, it seems to be fine now. I just took it out back and it shot fine. Weird. It could have been the barrel, who knows. I still don't know how it could just randomly dry fire.

Anyways, from now on I'm going to start maintaining my guns properly, starting with keeping the batteries out when not in use and cleaning the barrel more often. Hopefully this will make a big difference in the future. Thanks guys!
BGrail25 is offline   Reply With Quote
Old February 27th, 2010, 13:25   #9
CDN_Stalker
Official ASC Bladesmith
 
CDN_Stalker's Avatar
 
Join Date: Jul 2003
Location: Ottawa, Ont.
Send a message via MSN to CDN_Stalker
Put a few drops of oil down the loading tube (of the hop up unit) and cycle it, then try firing again. If it improves, lack of lube was the issue. If it acts the same way, then good chance your hop up rubber needs to be replaced.
CDN_Stalker is offline   Reply With Quote
Old February 27th, 2010, 13:31   #10
BGrail25
 
Join Date: May 2009
Will do. I've been meaning to ask, is something like gun oil Ok?
BGrail25 is offline   Reply With Quote
Old February 27th, 2010, 15:07   #11
NoGear
likes being humiliated
 
NoGear's Avatar
 
Join Date: Jun 2008
Location: Surrey BC
Quote:
Originally Posted by BGrail25 View Post
Will do. I've been meaning to ask, is something like gun oil Ok?
Pure non petrolium silicone oil only

i think paintball guns use the same stuff for 0- rings so visit a paintball store and pick some up and ask.
NoGear is offline   Reply With Quote
ReplyTop


Go Back   Airsoft Canada > Discussion > Doctor's Corner

Bookmarks

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Airsoft Canada
https://www.replicaairguns.ca/airsoft

All times are GMT -4. The time now is 12:21.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.