|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
October 3rd, 2011, 22:48
|
#1 |
|
Broken Lens :(
Hello, I broke my lens in my stream light tlr-1s last week and I can't get the thing completely apart. I took all the glass out and the rubber seal out and emailed them because it looked like it might have been glued in there, and sure enough they glued the threads. So my question is what is the best way to get it apart without damaging it. I figure I'll have to heat it up some how maybe to loosen the glue then thread it out but what would be the best way to do so? Thanks
|
|
|
|
October 3rd, 2011, 23:35
|
#2 |
|
I have a TLR-1 the same thing happen to me. I emailed them and they sent me a new front bezel with the glass already installed.
__________________
Team Zulu All worked on by me which means they only work half the time 
|
|
|
|
|
|
October 4th, 2011, 17:36
|
#3 |
|
Heat the threads with a heat-gun slow and carefully from all sides. This will destroy the glue. Use a vice.
__________________
Good Airsoft Techblog: (google translation works) http://airsoftaustria-tech.blogspot.com/ |
|
|
|
|
|
October 7th, 2011, 13:11
|
#4 |
|
|
Thanks for the reply's, streamlight said they'd replace or fix it for me to just send it to them so I'll do that. I did try heating it both with a heat gun and in boiling water and neither idea worked. My next idea was to use a vice and heat again but just decided to send it back.
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
