TM M92F Problems

[Dayto]

Well I just picked up a used M9 ,But today I whent to gas it up and The Green gas would not seal at all around the fill valve on the mags , So after waisting alotta green gas I figure there should be enuf to fire it , But it WILL NOT shoot at all not even Hiss , or Burp nothing I then drop the mag out Push the valve and have gas spray every where ,It seems like the gun is not hitting the preassure valve (Valve on the mag that you can push to release gas) so there for no gas is getting into the gun:banghead

Some please help me .

[Ibby]

Sounds like the hammer isn't working. You could try asking for a gun doctor here:

http://bcairsoft.com/forum/index.php
http://www.op-for.ca/forum/index.php
Both these boards are clubs based in Vancouver.

You could also try:
http://canadianservers.com/cia/index.php
These guys are up in Nanaimo, but I'm not sure if they have a local gunsmith at the moment.

[Dayto]

Thanks Ibby for the info (seem to always know you'r shit lol) Your right, I figured out the Problem , when the Hammer cocks back there is a Small Flat metal part that when the Hammer is Fired that part strike's the valve on the mag , So when I push the Flat metal thing(back) up against the hammer(when hammer cocked) giving it about 1mm or travel before striking the valve it fire's good ,but then the part gets stuck right agaist the valve giving the part no room to travel, so there for cant gain enuf power to open the valve.

So there must be a spring missing to hold the metal thing back in position to shoot.

[Ibby]

Yeah, sometimes the hammer spring can break. If wind up getting a new hammer spring get an upgraded one. It'll be less likely to break and you'll get a bit more speed out of the gun.