![]() |
|
|
||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
![]() |
|
Thread Tools |
![]() |
#1 |
BALLET, TYPE: SELF LOATHING, ANALBURST
|
416 inner barrel question
Simply put, what is the inner barrel length of a JG 416 with the crane stock? I need to know exactly for an upgrade I am planning.
|
![]() |
![]() |
![]() |
#2 |
About a regular 363mm M4 barrel with 3cm cut off. So 330 mm.
|
|
![]() |
![]() |
![]() |
#3 |
Red Wine & Adderall
|
Mine was under 300mm!
Dont ask my why because I dont know but it was nowhere close to the end of the outer barrel.
__________________
![]() "Its only a little bit on fire" |
![]() |
![]() |
![]() |
#4 |
BALLET, TYPE: SELF LOATHING, ANALBURST
|
My inner barrel is within an inch to two inches to the outside of my flash hider. Styrak is that just an educated guess? I don't want to end up buying a barrel and have to worry about cutting it down or it being too short.
|
![]() |
![]() |
![]() |
#5 |
I would suggest that you simply remove the inner barrel from your 416 and measure it. That way you know for sure without any guesswork required.
__________________
![]() |
|
![]() |
![]() |
![]() |
#6 |
Division
|
Mine was 285mm.
__________________
![]() Weee! |
![]() |
![]() |
![]() |
#7 |
formerly Sepulcrum
|
Just measured mine at 260mm, aprox. 1 1/2 inches from the tip of the flash hider making it just the right length for it to look perfectly real.
|
![]() |
![]() |
![]() |
#8 |
BALLET, TYPE: SELF LOATHING, ANALBURST
|
Ok Im going to guess that these barrels are all different lengths then or something lol. I'll try pulling mine out tonight and measuring it up then.
|
![]() |
![]() |
![]() |
#9 |
formerly Sepulcrum
|
Lol... yeah JG is very very random when it comes to consistency in their product.
|
![]() |
![]() |
![]() |
#10 |
Yeah, it seems to be that way from all reports of JG guns. One example being the mechbox in mine. Everyone so far seems to report an SB-stamped mechbox, whereas mine is stamped UTG instead.
I was curious, so I just checked out my inner barrel. Mine runs the full length of the outer barrel right to the flash hider. It measures up at 288 mm.
__________________
![]() |
|
![]() |
![]() |
![]() |
#11 |
I cut off 3cm and it worked fine. Stuck out of the outer barrel a little, but not so much that you could see it through the cuts of the flashhider, viewing the gun sideways.
|
|
![]() |
![]() |
![]() ![]() |
|
Bookmarks |
Thread Tools | |
|
|
![]() |