M4 Front wired quick release.

[slowbird]

I'm getting tired of having to cut and re solder my Deans connector on my front wired KA M4 whenever I want to take it apart.

I have read some things about installing an inline quick release to help with this.

Has anyone gone this route and what connectors did you use? Butt connectors? Spade?

The gun is pretty much stock so I don't think there will be any issues adding this but I'm unsure, so I'm asking here.

Thanks in advance.

Oh! ...and no I don't wish to rear wire the gun to the stock. Atleast, not anytime soon.

[jpogue03]

I use bullet connectors in the front end of my M727, very simple to install and provide a sturdy connection. Yes, they are small enough to fit through the wire opening in the receiver.
Ought to be available at your local hobby shop for next to dirt cheap. In case you don't - http://www.hobbyking.com/hobbyking/s...irs_20pc_.html

[Bahhwa]

Originally Posted by jpogue03

I use bullet connectors in the front end of my M727, very simple to install and provide a sturdy connection. Yes, they are small enough to fit through the wire opening in the receiver.
Ought to be available at your local hobby shop for next to dirt cheap. In case you don't - http://www.hobbyking.com/hobbyking/s...irs_20pc_.html

I can vouch for this cause its actually what i use too

(big picture sorry)

[slowbird]

Very nice.

Thanks JP, and Bah for the pic. Looks like a perfect solution.

[venture]

Yep, gold bullet connectors with shrink tubing over them is best for front wired.