G36C 9.6V Fit

[byblos]

I have a TM G36c, currently using a mini 8.4V battery. Has anyone been able to fit a solid mini 9.6v battery or a mini nun-chuck 9.6v battery into the original hand-grip battery casing?

Thanks

[deep in the bush]

Yup...

there is a small tab inside front of the g36 that holds the 8.4 in place. remove it. It should fit.

It can be a tad tight but I made it fit a few years ago.

I also rewire the batts to the stock, not as pretty but you can add a huge batt so never need to change it all day.

[chaosnemesis]

a 9.6 nunchuck fits in my ca. Since it's based off the tm i would assume it will fit yours.

battery bag on the stock? eeeeew. It'll interfere with the foldability of the stock or the wires may get snagged. I'd rather get the acm large handgaurd. A better alternative would be a large cap. 7.4V lipo.

[byblos]

ty ill try out a nun chuck. Thanks, just wanted to make sure.

[Kos-Mos]

You can fit a 9.6v mini no problem.

You have to remove/break the batter retaining tab if you have a TM.

If you have a K/E non railed handguard, I also recommend you to remove the heat shrink on the battery and hot glue the battery (a thin fillet between the two rows is enough).