GBB Mag o-ring

[BrokenBird]

Where can I get the o-ring for GBB mags? I lost a ring from one of mine, and it is quite hard to fill now with gas shooting all over the place.

(I am talking about the very small ring around the input valve)

[ShelledPants]

What brand and type of mag?

[BrokenBird]

Well I guess they are all the same, anyway my Glock 19 and KJ M19 seems to be using the same o-ring.

[Murdoch]

In the mean time, try using some plumbers tape or maybe some blue locktite. I've used the tape before and its worked very well. Just cut the strip in half and about an inch long and wrap it around. It may take a few times to figure out the right amount of turns to seal well.

Hope it helps.

M

[BrokenBird]

Good idea I will try that.

BTW Murdoch, were you able to fix the Glock?

[heikis]

how about these: http://www.wgcshop.com/wgc2008/main/...C-PT-G18-FIVOR

[Murdoch]

Yes, BB, the G19 is working well. I took it apart completely, cleaned it with mineral spirits to get every bit of grease out, put it back together (lubing where needed) and she worked well.

Some internals like the hammer are a little worn and could use replacing but otherwise it shoots good. Cheers!

/thread jack

Originally Posted by BrokenBird

Good idea I will try that.

BTW Murdoch, were you able to fix the Glock?

[dpvu]

You may be able to use the o-ring off one of those cheap Bic butane lighters. I've heard they're about the same size as the fill valve o-rings. Worst case scenario you have to get a new fill valve but they're cheap.