ICS Hop Up rubber

[RaisinBran]

How do you put the hop up rubber back on? (the small black rubber thing)

[incrediboy729]

This can be easily foun don google.......
Assuming you're talking about the bucking, (a rubber cylinder about two-thirds of a centimeter in diameter and three-quarters of an inch long). Take your inner barrel, find the end of it that has a hole in the top. Take the bucking, find the end that has a "nub" on the inside and place it on the barrel so the nub is pointing down into that hole in the top of the barrel. There should be a line on the bucking and a groove on the barrel that should line into each other.

[RaisinBran]

Originally Posted by incrediboy729

This can be easily foun don google.......
Assuming you're talking about the bucking, (a rubber cylinder about two-thirds of a centimeter in diameter and three-quarters of an inch long). Take your inner barrel, find the end of it that has a hole in the top. Take the bucking, find the end that has a "nub" on the inside and place it on the barrel so the nub is pointing down into that hole in the top of the barrel. There should be a line on the bucking and a groove on the barrel that should line into each other.

I googled it, searched it on ASC, no luck...but thanks also... I got it to work and your way is for a regular Hop Up. ICS has some strange but great Hop Up design

[KND]

the easiest way is to punch out the pin ( there is only one pin ) then you can put that small rubber thingy in there.

Edit : you may find your way around to take out that pin, which one is work for you then go for it.