TM Style 2 Piece M4 Hop Up Unit

[Boris the Blade]

Hello fellow ASC members, I have recently acquired a HurricanE 416, and I am looking for a TM Style 2 piece hop up unit for M4 type guns, I was wondering if there are any aftermarket alternatives, I searched ASC and online and drew a blank. Perhaps I didn't narrow my search down enough, it is a very specific part, hopefully someone else has had similar issues and have found this part. I have a one piece metal G&P hop up unit installed at the moment, but it is a pain in the ass to disassemble my gun as a result of this.

EDIT: Perhaps I should have posted this in the doctors corner or in the general thread, if an admin would be kind enough to move it to the appropriate thread it would be appreciated.

[JEEPEE]

Like this?

http://www.airsoftgi.com/product_inf...roducts_id=900

This one fit for TM/CA M4/M16 but I can't confirm it will fit for you. Maybe someone here can confirm this for me...

[Boris the Blade]

Originally Posted by JPCD002

Like this?

http://www.airsoftgi.com/product_inf...roducts_id=900

This one fit for TM/CA M4/M16 but I can't confirm it will fit for you. Maybe someone here can confirm this for me...

Thats EXACTLY what I am looking for. Thank you very much for that. Perhaps someone can confirm if it will fit on a HurricanE 416 body?
Its unfortunate that the unit is not in stock. I have seen that airsoftparts.ca and another site sell the guarder replacement for the stock TM unit, but they only sell half of the unit! Where can I find the part that attaches to the lower receiver?

[ILLusion]

If you have a one-piece hop up chamber already installed, then it will be impossible to install the two-piece Marui chamber, as it does require a platform to hold the feed tube to the lower receiver. This platform is typically removed to allow fitment of a one-piece hop up chamber. You are pretty much SOL on this, unless you want to downgrade your 416 to an original unmodified plastic Tokyo Marui lower receiver.

If you still want to give it a shot, I sell both halves of the unit. However, my advice is to stick with the one piece hop up unit. It's way more efficient in gas usage and way more durable. The losses you would suffer by going to this crappy archaic two-piece system will far outweigh any gains you may achieve with the ability to swing open your upper receiver for a "quick takedown." For the purposes of airsoft AEG's, you would gain nothing by being able to do that, except the ability to store the carbine in a more compact form. There are ways to do this with one-piece hop ups as well.

[HKGhost]

or sometimes when the lower is modded for a one piece unit, material is left on either side with the screw holes for a two piece unit to be mounted. But it depends if it was modded this way or all is gone.

[Boris the Blade]

My 416 DOES have the mounts, but you are saying that a one piece unit is better for airseal and durability. So I will stick with the one piece unit. I will have to find another way to take down my 416, the way I have to do it now is a pain and is damaging my selector plate/ cutoff lever since I have to force the two halves apart horizontally.. I also have to pull out my barrel out all the way, lost the spring on the front of my hop up unit by doing this.