Cracking open tm p90 body?

[DarkAngel]

The lower is not illegal to import. Why not just buy a new TM Lower from the US?

[ArcticFox1984]

If its anything like the foregrip of a TM AUG...

The glue will melt @+90c, just shy of the boiling temperature of water.

Just plunk it in some very hot water for 5-10 minutes then pry it apart slowly and carefully.

Repeat as necessary and be careful not to damage the plastic as you pull the pins out of their sockets.

You can buy the same type of glue at most hobby shops to reapply when you are putting things back together.

Just make sure you don't put any glue on the pins or you'll never get it apart again. ( Though most don't need to the first time. )

[Slow]

http://www3.sympatico.ca/aftershock/intlaser.html

[D.Kovacs]

hmph, thought the link still worked. Sorry man.

[PrIeSt]

Originally Posted by DarkAngel

The lower is not illegal to import. Why not just buy a new TM Lower from the US?

Thanks for reading the thread..

I think I can get a laser in without opening. Mountings a different story. Need to find the right laser

[PrIeSt]

Originally Posted by Slow

http://www3.sympatico.ca/aftershock/intlaser.html

Slow thanks missed your original post. That's the one I saw some time ago and may work if I can find a small red or green laser that I can take apart. Hmm

[Danke]

The Laser in the pistol grip Crimson trace copies is pretty small. You would have to lengthen the wires though.

[PrIeSt]

I've purchased a few of the pen light lasers. going see what I can basterdize in there. Really you have 2 inches of length easy. and I have good wire and micro connectors so I could run it back right to the battery if I want. As I plan to put in a push button.

Gotta see what will fit first.