|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
July 12th, 2010, 02:17
|
#16 |
|
no there's no o-ring on the fill valve.
|
|
|
|
July 12th, 2010, 03:37
|
#17 | |
|
Quote:
umm yah there is... there is a small one on the inside and a larger one on the outside. With these I find that I need to soak my fill valve the night before or they piss gas. *soak on oil* also fill in short bursts or the valve will usually end up sticking. If its pissing gas while filling I normally rotate the bottom or the nade and that tends to great a better seal. In short yes Oring Yes leaky when filling PS I would snap you a pic but it appears that my fill valve is freaking stuck... ironicly I bet its the oring lol PPS got the valve out. I apologize for the blurry pic but the oring at the tip of the tool sits around the fill valve. Last edited by Dart; July 12th, 2010 at 03:48.. |
|
|
|
|
|
July 14th, 2010, 01:51
|
#18 |
|
|
he's talking about the external; where the adapter goes to fill the grenade. My 3 grenades don't have one EXTERNALLY... they all have one internally - that only makes sense...
|
|
|
|
|
July 14th, 2010, 02:08
|
#19 |
|
Yup.
|
|
|
|
|
|
July 14th, 2010, 07:17
|
#20 | |
|
|
Quote:
|
|
|
|
|
|
November 14th, 2012, 21:57
|
#21 |
|
i just picked up the Impact Grenade and posted the same question here. When filling i get a venting after a couple of short fill bursts. I am not sure if it's filled all the way and simply venting any over fill.. or if it's actually leaking right out of the box. .brand new ..
At first i used Green Gas with a metal nozzle and now i'm using the same Madbull metal Propane adapter.. both have caused this venting. Could it be the metal fill stems in these types of adapters? |
|
|
|
|
|
November 14th, 2012, 23:02
|
#22 | |
|
I had a defective AI impact too. Maybe they got a bad batch of valves...
I have contacted AI before taking anything appart and they sent me a valve for free. Also metal adapters break valves. Get the tan AI one, it works great. The AI grenades fill from empty in about 2 seconds. It will spray a small cloud when full. Make sure you have reset the shuttle, installed the pin/plug (timer version) and screwed the top properly before fill. Also, you should not need to use anything but your hands to open/close the top threaded portion. It's not supposed to be on THAT tight.
__________________
Quote:
|
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
