CYMA M14 propper bolt lubrication

[-Shade]

Hey all,

I own a CYMA M14 EBR and I have an issue with the bolt. If you're a CYMA m14 owner, you definitely know how sexy pulling the bolt can sound, so onto my simple issue:

So, 50% of the time when I pull the bolt back and release, it doesn't move forward into place all the way. (stuck halfway) I've determined that it's most likely a lubrication issue and not the spring. I was wondering where I should lubricate it exactly and what to use. I own permatex white silicone and tune-up grease, as well as some guarder grease.

Is it just standard to just grease all of the moving parts?

Any input is welcome - thank you!

[Kos-Mos]

On mine, it was the fake bolt catch that worn down and caused jams.

Try removing it and check if it works. There is really not that many contact point for the fake bolt. The righ side is on a large brass bushing and left side has a little tab that slides. This tab gets punched and worn by the catch. If you want to lube something, this is what you want to lube.

[-Shade]

Thank you!

Originally Posted by Kos-Mos

On mine, it was the fake bolt catch that worn down and caused jams.

Try removing it and check if it works. There is really not that many contact point for the fake bolt. The righ side is on a large brass bushing and left side has a little tab that slides. This tab gets punched and worn by the catch. If you want to lube something, this is what you want to lube.