Will this upgrade work?

[AMetalSplinter]

For my Tm M16 A2, would a 190% spring, and some steel bushings be ok? Cos' its cheap on 007airsoft and Im not to bothered about the RoF. Yeah, just need to make this decision, thanks.

[Oddjob]

What brand 190%?... If your talking about a PDI 190% your never going to be let onto a feild as your gun will be running so hot its melting. That and your gears will turn into jello.

Read this topic before you post here again :
http://www.airsoftcanada.com/showthread.php?t=2738

For your insane spring ideas I sugest you read #10. Then I sugest you go through the spring guide and see whats what for approximates. PDI 190% isnt listed since its retarded and retailers should not even list the damned spring. Stay stock, be happy, learn to play.

[AMetalSplinter]

Oh, the melting bit doesnt sound too good. Thanks for the link

[Oddjob]

I figured the retarded bit would not sound good. A PDI 190% would put your gun way beyond field limits of 400FPS for auto AEG's. As in making other plays bleed when you get bare skin in CQB. But I guess that doesnt matter to you eh? You just want go fast low drag no matter the rules.

a 190% will without question make short work of your mechbox.
the highest spring we recommend(and fields allow) is a PDI 170% or equilivant M120

[firemachine69]

How about cutting back to a PDI 150, at most?

You seem to have no clue what you're doing, so please, play safe, or expect to shell out big cash to: 1. Have a gun doctor fix your mistakes, and; 2. Pay the parts for the gun doctor to replace.

[MinusII]

yeah a 150 sounds much better. I put a PDI 150% in my TM M4 with some metal bushings and i am very pleased with the results. it now shoots at 380-390fps and is extremely accurate. However it did completely kill my RoF. I tried to keep with my 8.4v 600mah but i was shooting WAY to slow and killing the bat. WAY to fast. So i went to a 9.6v 1700Mah and now its perfect. (other then the lack of metal body and 1piece outer barrel)

Minus