WA Kimber Warrior - can't fire -- valve misaligned?

[weaselgx]

Hi guys,

I've lurked on this board for quite a bit and it has been very helpful. Unfortunately, now I have a problem of my own and I can't seem to figure it out.

Anyway, I have a WA Warrior that doesn't fire. The trigger and hammer mechanism appears to be fine. However, when the hammer strikes, nothing happens. The mag is gassed up.

This problem arose when a BB got jammed exiting the magazine lip (due to a new Guarder magazine lip which was a bit tight). I had to rack back the slide, which was somewhat tight, to eject the magazine and clear the BB.

I'd appreciate any help you can give.

Thanks a lot!

[ClassicBAC]

I am using WA SVI6 SCW 3 and encounter something similar. I have disassemblied them all out and found that there are two things need to be fixed. From what I have analysed this is what had happened.

The SCW3 firing pin is having a hum comparing to SCW2. The hum seems to hit the sear joint then cause the locking pin (Lock the Firing pin to the hammer) bent.

The locking pin (Lock the Firing pin to the hammer) need to be replaced. I also file the SCW3 firing pin hum about 1 milimeter. They now seem to work properly again.