Help removing blowback chamber

[shadow_matter]

Hi,

I have a KSC/KWA P226 here, and I cannot figure out how to remove the blowback chamber and feeding nozzle from the slide. I have to strip the slide down so I can get it sandblasted.

I have tried removing the one screw but the unit still won't budge inside the slide. If anyone has ideas I would appreciate it.

Here are some pics.

[Sully]

Originally Posted by shadow_matter

Hi,

I have a KSC/KWA P226 here, and I cannot figure out how to remove the blowback chamber and feeding nozzle from the slide. I have to strip the slide down so I can get it sandblasted.

I have tried removing the one screw but the unit still won't budge inside the slide. If anyone has ideas I would appreciate it.

There should be an allen screw on the back of the slide where the hammer strikes the back of the slide. remove that screw and then it should just slide out.

[shadow_matter]

The only visible alan screw is the one I circled in the pictures. The little round nub where the hammer hits is a button that looks to be connected to the blowback unit.

Is there a way to remove the feeding nozzle first so I can get a better view of what is holding the blowback chamber in?

[Jugglez]

After you get that screw out push both sides of the slide outward with your fingers, and at the same time wiggle the chamber block up and out. Worked for me.

[shadow_matter]

Awesome, thanks Jugglez. I just gave it a good slap on my wrist and it popped right out.

Thanks guys.