Air Seal Nozzle Not Sealing Properly

[[]D[][]\/[][]D]

Well, with the o-ring in the nozzle, I placed a thin layer of silicone grease around the o-ring, about half a millimeter thin and now it's sealing properly with the ARS MASK cylinder head. Does anybody know how long this temporary fix will last me? Or is this fix good enough for the long run?

[ybrik]

Originally Posted by []D[][]\/[][]D

So I would then have to get something that has a smaller diameter than the o-ring from my nozzle, right?

you don't have to get similar diameter of your o-ring. It's in a grease form, remove your o-rings, apply it in the nozzles groove, flush it with the cylinder head, wipe excess and let it dry.

[[]D[][]\/[][]D]

Originally Posted by ybrik

you don't have to get similar diameter of your o-ring. It's in a grease form, remove your o-rings, apply it in the nozzles groove, flush it with the cylinder head, wipe excess and let it dry.

Are you talking about rubber gasket sealing compound? Because that's totally different from a rubber sealing gasket. Also, there are many types of sealing compounds out there, would you know the specific one?

[ybrik]

It's a gasket sealant. Much like those made by Permatex available at Canadian tire.