WE GBBR M4 Bolt

[BobbyDangerous]

Quick question on upgrading this. I can see now why. I upgraded the nozzle and it's hard on the bolt. The guides come loose. The one that screws in especially. I had to drill and mode the guide so that that screw would counter sink and grab more of the bolt. But what my question is this. On the steel bolt, is it prone to stripping as well under stress or just cause of the aluminum bolt, it's softer?

[daishi]

Ra-tech will always degrade your gun over time. You're using steel on softer metals.

Everyone is all about ra-tech and steel this and that. But your gun works perfectly fine stock with very minor upgrades like a inner barrel and hop and maybe a mod to the bolt catch.

All you needed to buy was those two things and a we open bolt conversion kit for 100 bucks to have all the spare parts you could want if anything breaks down the road.

Also instead of drilling and such, you could have just put some o-rings on the screw to make it stick. That way it grips and stays in, but its not permanent like a screw locking glue would be.

[BobbyDangerous]

Well I would have left it stock if the stock nozzle had Npas.

[BioRage]

You coulda spent $20 on a npas kit and installed it in the stock nozzle o.O

[BobbyDangerous]

I didn't even know you could do that. Hahahahahaa

[BioRage]

http://www.airsoftparts.ca/store2/in...oducts_id=2047


google + youtube mate

[Zack The Ripper]

Originally Posted by BobbyDangerous

I didn't even know you could do that. Hahahahahaa

There are multiple GBBR threads on the forums, and an NPAS is one of the most widely recommended upgrades on all of those threads. You should really do some more reading before blowing money on expensive shit.

[BobbyDangerous]

Originally Posted by BioRage

http://www.airsoftparts.ca/store2/in...oducts_id=2047


google + youtube mate

Yeah I found it on there.

Thanx guys. I just got into gas guns. Now I know. I appreciate it. Cheers