Removing Stock from M-3081A Electric Plastic Boyi

[031247]

mounted it when i bought it but i am wondering how do i take it apart? theres a switch at the bottom tried turning that then pulling it out no good.

[MrEvolution]

if Im guessing correctly, you pull down on the tab and then the stock should slide right off, leaving the tube there.

[031247]

the trigger is used for extending it but theres a switch there but that dosen't work

[techobo]

Pull it down instead of pushing it up.

[031247]

well when i put it in it went up to down so not i have to keep pushing it down?

edit it does not go down as u see there is a block there so it goes 1 way

[acidburn149]

[031247]

thanks for trying but thats not how it comes off

[acidburn149]

well i dunno dude everyone i have taken apart thats how the butt stock come off the bar... then once you get the butt off there a small Phillips (very small) to take off the very back of the bar at the but stock slides on then once you get the cover with the small screw off there a large Phillips inside the bar which once you unscrew the bar pulls off!!

(and where you say "Trigger for making it longer and shorter i understand that.. but instead of pushing up on it as you do do make it long or short..... grab the end and pull down and then pull back on the stock!! ... (it has to be extended all the way first))

[031247]

nope tried that thanks for trying :|

[acidburn149]

whos the gun made by

[031247]

ukarms.com

[acidburn149]

ya but WHO made it.. Tokyo Marui, Classic Army ?????

[TokyoSeven]

Im guessing thats who made it, I googled M-3081A and came up with very little helpful info.

[031247]

yea looked through the manual not really anything helpful

[TokyoSeven]

Dont be afraid to give it a little elbow grease.
I know on my TM m4, she dont come off unless I giver a good yank.
Basically I sit on the couch with the M4 on my lap. I pull down on the stock slider grip and then pull off the stock backwards, but she takes a good rip to get it off.