|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
July 27th, 2008, 14:07 | #1 |
BALLET, TYPE: SELF LOATHING, ANALBURST
|
Mosfet/3 shot burst programming?
Ok the SAM-R that I bought has a 3 shot burst which can be disabled by pulling a "pin" so I can get my single shot back. What I was wondering though is how hard is it to switch the 3 shot burst to the full auto position instead of the single shot position.
|
July 27th, 2008, 15:02 | #2 |
Official ASC Bladesmith
|
Not sure exactly the circuit you have, but I had one that had a small black computer jumper between a pair of wires, set it to normal mode, safe, semi and full. Put it back in, gives you safe, 3rd burst and full auto.
And you can't switch it at all, the burst function needs the cut off lever to be able to fire burst in the semi mode. |
July 27th, 2008, 15:06 | #3 |
A Total Bastard
|
The one stalker has in his Mp5 is mega cool, works on the full auto setting, just burbs out two shots, if u hold the trigger after then u get full auto, otherwise just tap tap tap and u get burp burp, burp burp. Very neat little units indeed.
__________________
W1-5 |
July 27th, 2008, 15:28 | #4 |
BALLET, TYPE: SELF LOATHING, ANALBURST
|
Ok thanks anyways, looks like it will be disengaged then, what a waste....
|
July 27th, 2008, 17:38 | #5 |
Official ASC Bladesmith
|
What is semi auto anyways? What is it used for?
I have a Trigger Master in each of my MP5s, previously I had some burst circuit bought through RedWolf I think that made the semi into burst. Good unit and relaible, but not for making the full auto function into burst mode (only the Trigger Master will do that). |
|
Bookmarks |
|
|