Stock Options

[m102404]

Not the kind you buy and sell on a financial exchange...the kind you stick on the end of your rifle

I'm stuck a bit on a new M4 build...and your combined thoughts/opinions are appreciated. I've spent more than a little time trying to figure this out and Jugglez and I kicked around the ideas yesterday but came up blank as well.

I want to run the following:
- Triggermaster3 MOSFET (biggest reasons are the 3rnd burst, and switch protection)
- 11.1v LiPo (probably stock tube size...but open to options)
- KA 11.1v Cutoff circuit (about the length of a fuse holder...but about half the thickness)

As you can imagine, this is a lot of junk to tuck away in a rifle. I've put a stripped down Triggermaster Mk1 and stock tube LiPo in my CQB M4...and was able to tuck the mosfet up inbetween the outer barrel and handguard...and the LiPo in my stock tube. Missing the cut-off circuit...and relying on caution and the Triggermaster's 83% low voltage warning.

The front end of the new setup will likely not have enough space between the handguard and the outer barrel for a Triggermaster MK3...which seems a bit "blockier" than the older models. It might have enough space for the cut-off circuit. I know a CASV would have plenty of room and then some...but the one I'm looking at probably will not. A full stock is not suitable.

So I'm looking for options. I'd like a "clean" collapsible stock (the current Magpul CRT is really nice). I'd prefer not having to run strands of wire back and forth between the front and back of the rifle as I have in the CQB M4...it works...it's just a pain to work on the rifle afterwards. Real ready mags are cool...fake ones are fake. Hollow Eotechs are odd...what are you going to aim with? The "tubes" of a MOD stock are too small in diameter for a LiPo and will be really tight, if not a no-go, for the triggermaster. Battery bags are out of the question. I am going to run a weapon light on the right side and a vert grip on the bottom...I do not care for PEQ boxes...and it might look funny on this build as I'm going for mean and lean vs. transformer/Mr.Gaget front end.

No too picky, eh?

My best option at the moment is to use a CA Crane stock that can hold large batteries. The lipo will go in the middle or down one side...the mosfet and cutoff circuit in the other side or middle. Or a HK416/417 stock would hold it all easy. But the big bulbous stocks might look kind of funny.

Any setup options that we've missed? Any other stocks out there that could hold all this?

OR DONP CAN JUST MAKE ME A LOW PROFILE TRIGGERMASTER THAT HAS A SELECTABLE 11.1V/7.4V CUTOFFCIRCUIT THAT I CAN JIMMY BETWEEN THE OUTER BARREL AND HANDGUARD!!!!

Thanks guys,

Tys