G&G M14 in a Norinco M14s stock?

[Rock 'N' Roll Outlaw]

Hey folks, quick question for those in the know. I have a G&G M14 with a synthetic stock, and personally I can't stand the feeling, texture as well as the fragility of the ABS. I have been looking into obtaining a real wood stock for it, but have been unable to find a G&G stock for it. I recently came across a Norinco M14s real steel stock and was just wondering if I would be able to use this for my G&G.

I know I would have to carve and mill out the buttstock for the battery compartment, but other than that, what other work will I be looking at to make it work if it can be plausible.

Any and all feedback would be appreciated.

[Rock 'N' Roll Outlaw]

Anyone have anything to say on this matter?

[Lakonian]

My teammate had a RS G.I stock installed on his M14 by TM, but that was TM. I hear G&G and TM's M14 are quite dissimilar.

The mod took a bit of dremeling. I'm sure Tys can tell you all 'bout it.

[Rock 'N' Roll Outlaw]

Awesome, Im gonna see him tonight at the CQB game, so I'll run it by him.

[moto]

Dentrinity.com has a G&G Walnut stock. $166 USD

http://www.dentrinityshop.com/den_se...14&pg=2&rpp=10

Shouldnt be a problem getting it into the country. Ive ordered stocks like this before and they came through without issue.

[Dao]

If I'm not mistaken the Classic Army M14 is a clone of the G&G M14 so I think you might be able to get the Classic Army M14 Real Wood Stock to fit on your G&G with minor modification if any at all.

[BeAcH]

you could also use a battery bag too, instead of milling out the stock...just a thought, should work pretty good.

[SHÖCK]

Originally Posted by BeAcH

you could also use a battery bag too, instead of milling out the stock...just a thought, should work pretty good.

Or conversely, just get a nice and small tube shaped lipo and just drill a round shaft versus milling.